RVLifeJourneys.com

Your RV black tank valve should stay closed except when you are actively dumping or flushing the tank. Your gray tank valve is also best kept closed by default, although you can leave it open during...

Black tank treatment and tank rinsing do different jobs, so neither completely replaces the other. Tank rinsing physically removes loose waste and residue, while black tank treatment helps manage...

Wastewater usually remains in an RV sewer hose because the hose has a low spot, poor slope, or uphill section. These areas trap liquid because gravity cannot carry it completely into the campground...

When the sewer inlet is higher than your RV outlet, gravity may not fully drain your holding tanks. For a small height difference, drain as much as possible and carefully lift the sewer hose toward...

To position an RV sewer hose support on uneven ground, start high near the RV waste outlet and gradually lower the support toward the campground sewer inlet. Adjust individual sections as needed so...

An RV waste-valve handle usually becomes hard to pull because the gate blade is dragging against dry, dirty, or worn rubber seals. Waste buildup, a binding cable, corrosion, misalignment, or freezing...

An RV waste valve can still leak after replacing the seal when the new gasket gets pinched, twisted, or installed slightly out of position. Debris inside the valve groove, uneven bolt pressure...

If your RV macerator is running but not pumping waste, the most likely causes are a closed or restricted waste valve, clogged inlet, kinked discharge hose, air entering the pump, or a worn or damaged...

An RV macerator pump grinds waste and pumps it through a smaller hose, while gravity dumping lets wastewater flow naturally through a larger 3-inch sewer hose. Gravity dumping is usually simpler and...